Wheatheart X13 Right Angle Drive Kit User Manual download pdf

PART NUMBER: 30795 R1

EVISED: 23/11/12

Before starting installation:

• Familiarize yourself with all the required hardware.

• Arrange all parts for easy access.

• Refer to the X13 assembly and operating manual for assembly safety and

operating instructions.

PRE-INSTALLATION

To prepare auger for kit installation:

1. Park auger on level ground. Fully lower the auger tube scissor lift.

2. Chock auger wheels to prevent rolling.

3. Relieve pressure in hydraulic hose(s) and disconnect them from tractor.

4. Position the hitch jack to support auger intake, then unhook tractor from

auger.

5. Install support leg as shown in Figure 1.

Important: The pin must be placed through the auger hitch. Do not use support leg without

pin in place!

6. Remove hitch jack.

7. Remove sprocket guard from boot.

8. Remove CV-PTO Driveline from auger by driving out the PTO roll pin.

X13 RIGHT ANGLE DRIVE KIT [A267]

FOR X1374, X1384, & X1394 AUGER MODELS

INSTALLATION INSTRUCTIONS

Wheatheart

part of theAg Growth International Inc. Group

P.O. Box 39, Rosenort, Manitoba, Canada R0G 1W0 Ph: (866) 467-7207 Fax: (866) 768-4852

Website: www.wheatheart.com Email: sales@wheatheart.com

Growth International Inc. 2013

1 2 3 4 5 6 7

Summary of Contents

Page 1 - PRE-INSTALLATION

PART NUMBER: 30795 R1REVISED: 23/11/12Before starting installation: • Familiarize yourself with all the required hardware. • Arrange all parts for eas

Page 2 - PIN [18074]

2Figure 1 Installing Support LegRIGHT ANGLE DRIVE INSTALLATIONNote: The gearbox is sent from the factory filled halfway with EP90 oil. Before further

Page 3

312. If necessary, adjust bottom drive chain to about 1/4” (0.64 cm) deflection by loosening the 4 bolts on the lower bearing, then retighten. (Oil th

Page 4

4Figure 4 Installing Gearbox and Jack MountGEARBOX / ADJUST PLATE NUTS [19600]GEARBOX MOUNT ASSEMBLY [20110]HITCH TUBE [29983]5/8” X 5-1/2” BOLTS [201

Page 5 - 3/8” CLEARANCE

5Figure 5 Adjusting Gearbox and Installing Coupler Chain3/8” CLEARANCE

Page 6 - PTO DRIVELINE

6PTO DRIVELINE1. Clean paint from gearbox input shaft.2. Slide the PTO driveline onto the gearbox input shaft, using a 3/8” x 1-3/4” square key. Tig

Page 7

7Figure 7 Installing the PTO Drive Guard and Guard Attach Plate

Comments to this Manuals

No comments

Wheatheart X13 Right Angle Drive Kit User Manual

Browse online or download User Manual for Special machinery Wheatheart X13 Right Angle Drive Kit. Wheatheart X13 Right Angle Drive Kit User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Special machinery Wheatheart X13 Right Angle Drive Kit